Description
The M1430 JÖRG Coil Fed Laser 2010 Used is very efficient when processing large quantities of thin sheet, up to 2 mm thick. The laser cuts directly from coil, allowing large lengths to be cut at once. This machine is suitable for cutting steel, stainless steel, aluminium, zinc, copper, etc. This machine is well suited to both the insulation and HVAC industries, as well as high volume production.
Equipped with:
- 2 kW YLS 2000 U Laser source + chiller
- Straightener
- Roll of table 2 metres
- Extractor
- Year of construction: 2023
Possibilities
- Ideal for thin sheets, very successful for insulation sheet metal.
- No cutting splashes on the underside of the sheets.
- No damage on the underside of the sheets.
- High material efficiency
- With special software, ideal for air duct production and insulation cladding
- Customer specific configuration possible
Cutting from coil
The JÖRG-Laser cuts directly from the coil. This increases the material used efficiency, and the sheet supply to be efficient. In addition, the length of the products to be cut is not limited by the machine. By setting up multiple decoilers for the machine, with an automatic selector, it is possible to quickly switch materials.
Fiber laser
The JÖRG-Laser is equiped with an IPG Fiber laser. The capacity of the source is tuned to the material to be cut. Advantages of the fiber laser: high cutting speed, low energy consumption, and less maintenance required.
Applications
Insulation cladding, ir duct fittings, thin sheet: steel, stainless steel, aluminium, copper, zinc, etc. Suitable for serial production, high volume production, production of complex nested parts and can be used as a replacement for punch lines.
Autodesk CAMDuct or EUROSOFT HVAC software
Optional software for efficient management of the production of air ducts, insulation cladding, and similar products: developing, nesting, and programming. With a database of standardised products.